Republic Starfighter

Included with the listing are the starfighter parts, pilot miniatures with various helmet choices, as well as supported and unsupported versions of files.

AT THIS TIME WE DO NOT HAVE A VERSION OPTIMIZED FOR FDM PRINTING. That being said, it still can be printed on FDM printers using autogenerated

The Republic Starfighter is articulated! The wings can open and close.

All parts will fit onto Anycubic Photons, Elegoo Mars, or similarly sized printers.

Designed for Resin SLA, and DLP printers. The original model is made for 1:46-1:48 scale.

It has been designed to fit onto Games Worksop Flying Bases

https://www.games-workshop.com/en-US/Flying-Stem-and-Base

Recommended Settings: 

*Resin Printers*

Layer Height: 0.04 to 0.15mm depending on preference

Comes either pre-supported or unsupported.

***If you decide to support and print the unsupported files, be sure to hollow out each piece, allowing for a 2-3mm wall. Add plenty of drain holes. additional supports may be required for the insides of interior sections***

Perfect for tabletop gaming, wargaming, dioramas, and hobbyists. Everything in our webstore is completely unofficial. It is not endorsed by or affiliated with Disney or Lucasarts.

Please do not share or sell these files or print to sell after purchase

-Upon purchase, the End-User agrees to print these files for personal use and not for any commercial printing endeavors